In
archaeology
Archaeology or archeology is the scientific study of human activity through the recovery and analysis of material culture. The archaeological record consists of artifacts, architecture, biofacts or ecofacts, sites, and cultural landsca ...
a section is a view in part of the
archaeological sequence
In archaeology, seriation is a Relative dating#Archaeology, relative dating method in which assemblage (archaeology), assemblages or artifact (archaeology), artifacts from numerous sites in the same culture are placed in chronological order. Wher ...
showing it in the vertical plane, as a
cross section
Cross section may refer to:
* Cross section (geometry)
** Cross-sectional views in architecture & engineering 3D
*Cross section (geology)
* Cross section (electronics)
* Radar cross section, measure of detectability
* Cross section (physics)
**Abs ...
, and thereby illustrating its profile and
stratigraphy. This may make it easier to view and interpret as it developed over time.
Sections
Half-sectioning is the usual method whereby one half of a
feature
Feature may refer to:
Computing
* Feature (CAD), could be a hole, pocket, or notch
* Feature (computer vision), could be an edge, corner or blob
* Feature (software design) is an intentional distinguishing characteristic of a software item ...
is excavated and the remainder left in situ. Large linear features may be sectioned at intervals along their lengths. Sectioning has fallen out of favour in some schools of practice because detail is often missed in section that is important to the
phasing
A phaser is an electronic sound processor used to filter a signal, and it has a series of troughs in its frequency-attenutation graph. The position (in Hz) of the peaks and troughs are typically modulated by an internal low-frequency oscil ...
of the site. Examples of detail that is revealed poorly "in section" include gravel or thin cobbled surfaces. The main problem with sections is the arbitrary location of their placement may "clip" or "just miss" contexts that reveal a different story form the one interpreted by the archaeologist. For instance thin liner features such as wheel ruts may be sectioned at an oblique angle giving the impression of a wider feature as the eye and brain tends to assume that features revealed in section have been cut at right angles to the orientation the feature was made. Numerous other false readings of sections are possible to the unwary, this is why excavation "in
plan
A plan is typically any diagram or list of steps with details of timing and resources, used to achieve an objective to do something. It is commonly understood as a temporal set of intended actions through which one expects to achieve a goal.
...
" is now preferred. Sections are used in conjunction with two-dimensional excavation by
plan
A plan is typically any diagram or list of steps with details of timing and resources, used to achieve an objective to do something. It is commonly understood as a temporal set of intended actions through which one expects to achieve a goal.
...
to determine the origin of archaeological remains. For recording purposes sections are normally drawn at a scale of 1:10 or 1:20 with their height related to the site
benchmark
Benchmark may refer to:
Business and economics
* Benchmarking, evaluating performance within organizations
* Benchmark price
* Benchmark (crude oil), oil-specific practices
Science and technology
* Benchmark (surveying), a point of known elevati ...
which in turn is related back to a level fixed at some agreed standard of
sea level
Mean sea level (MSL, often shortened to sea level) is an average surface level of one or more among Earth's coastal bodies of water from which heights such as elevation may be measured. The global MSL is a type of vertical datuma standardise ...
. Orientation should also be recorded. If the section is instructive a photographic record may also be made.
Stratigraphic control
Sections may also be employed in excavation in temporary fashion as a form of stratigraphic control so as to ascertain the
relationship between two or more
contexts which may be better examined by the use of a section. Then once a relationship is established contexts can be removed from site in the reverse order they arrived in accordance with the stratigraphic excavation and the creation of a
Harris matrix
The Harris matrix is a tool used to depict the temporal succession of archaeological contexts and thus the sequence of depositions and surfaces on a 'dry land' archaeological site, otherwise called a 'stratigraphic sequence'. The matrix reflec ...
for the sequence being investigated.
It is up to the archaeologist on site to determine the best local on site strategy for excavating deposits, be it "in section" or "in plan". In this regard the modern archaeologist uses sectioning as a tool for understanding the site stratigraphically during excavation rather than as an end goal in recording it. These caveats aside sections remain a powerful tool for archaeological investigation. A revival of digging in section with machines has occurred in recent years by a proliferation of limited time constrained development led excavations.
Quarter sectioning
Sometimes called digging by quadrant this special case is a procedure for excavating circular features, usually mounds and,
barrows, Deposits are excavated from four quarters of the feature, starting with two diagonally opposite quadrants and perhaps ending with the other two. The quadrants are slightly offset, so that the outer
balk
In baseball, a pitcher can commit a number of illegal motions or actions that constitute a balk. Most of these violations involve pitchers pretending to pitch when they have no intention of doing so. In games played under the Official Baseball R ...
of one is continuous (in reverse) with the outer face of its opposite, going through the center of the feature. After the recording of the sections, the balks may be removed and the rest of the feature excavated. The advantage of quarter sectioning is it allows a look at two complete cross-sections while still allowing excavation in plan thus allowing a better interpretation of the stratigraphy of the site. The merits of this sectioning and balk creation are disputed.
See also
*
Archaeological association
This page is a glossary of archaeology, the study of the human past from material remains.
A
B
C
D
E
F
...
*
Archaeological context
This page is a glossary of archaeology, the study of the human past from material remains.
A
B
C
D
E
F
...
*
Archaeological illustration Archaeological illustration is a form of technical illustration that records material derived from an archaeological context graphically.Barker 1977
Overview
Archaeological Illustration encompasses a number of sub disciplines. These are:
* '' S ...
*
Archaeological plan
In archaeological excavation, a plan is a drawn record of features and artifacts in the horizontal plane.
Overview
Archaeological plan can either take the form of
* a "multi context" plan, which is drawn with many contexts on it to show rela ...
*
Cut (archaeology)
In archaeology and archaeological stratification, a cut or truncation is a context that represents a moment in time when other archaeological deposits were removed for the creation of some feature, such as a ditch or pit. In layman's terms, a cu ...
*
Excavation (archaeology)
*
Feature (archaeology)
In archaeological excavation, a feature is a collection of one or more contexts representing some human non-portable activity, such as a hearth or wall. Features serve as an indication that the area in which they are found has been interfered w ...
*
Fill (archaeology)
In archaeology a fill is the material that has accumulated or has been deposited into a cut feature such as ditch or pit of some kind of a later date than the feature itself. Fills are an important part of the archaeological record as their forma ...
*
Harris matrix
The Harris matrix is a tool used to depict the temporal succession of archaeological contexts and thus the sequence of depositions and surfaces on a 'dry land' archaeological site, otherwise called a 'stratigraphic sequence'. The matrix reflec ...
*
Relationship (archaeology)
An archaeological relationship is the position in space and by implication, in time, of an object or context with respect to another. This is determined, not by linear measurement but by determining the sequence of their deposition – which arriv ...
*
Single context recording
Single context recording was initially developed by Ed Harris and Patrick Ottaway in 1976, from a suggestion by Laurence Keen. It was further developed by the Department of Urban Archaeology (Museum of London) from where it was then exported, in ...
*
Spit (archaeology) In the field of archaeology, a spit is a unit of archaeological excavation with an arbitrarily assigned measurement of depth and extent. It is a method of excavation employed without regard to the archaeological stratigraphy that may (or may not) b ...
References
*The MoLAS archaeological site manual MoLAS, London 1994. {{ISBN, 0-904818-40-3. Rb 128pp. bl/wh
Methods in archaeology
de:Grabungsschnitt